This will ONLY work for copiers set up using the steps found in this KB article: https://kb.scasd.org/x/AwKSAg
Instructions
Configuring the Copier
| Info |
|---|
When setting up the copier, verify that you use the TOSHIBA MonoMFP-X7 driver |
If not, you can do the following to add the function:
Select copier queue
Go to Options & Supplies...
Select the Options tab
Change Finisher to the correct type found in this KB article https://kb.scasd.org/x/AwKSAg
Click OK
Print the Document
| Info |
|---|
Copier Staple/Hole Punch Limitations
|
Within the print dialog box, verify that a copier has been selected
Switch to Finishing
Change Stapling to the desired setting
Change Hole Punch to the desired setting
Select Print
| Tip |
|---|
If there are any questions or issues please contact IT Services |
Related articles
| Page Properties | ||
|---|---|---|
| ||
|
| Filter by label (Content by label) | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|